> Addressable Fire Systems>APOLLO XP95/DISCOVERY >XP95/Discovery Fire Detectors >Apollo XP95 High Temperature Detector
Apollo XP95 55000-401 High Temperature Detector View larger

Apollo XP95 High Temperature Detector

55000-401APO

New

  • A high quality Type CS high temperature (90°C) heat detector.
  • Fully compatible with C-TEC's XFP & ZFP XP95/Discovery Addressable Fire Panels.
  • Monitors temperature by using a single thermistor which provides a voltage output proportional to the external air temperature.
  • Responds well to flaming fires with high heat output.
  • Typically used in areas where smoke detectors cannot be installed such as kitchens.
  • Red LED illuminates when the detector is in alarm.
  • Certified to EN54-5 by the LPCB.
  • Requires a 45681-210APO standard base or 45681-242APO low power relay base.
  • 'Xpert' card addressed for speedy installation.

By buying this product you can collect up to 27 loyalty points. Your cart will total 27 points that can be converted into a voucher of $5.40.


By buying this product you can collect up to 27 loyalty points. Your cart will total 27 points that can be converted into a voucher of $5.40.


Technical Specifications

Approvals/certifications Certified to EN54-5 by the LPCB.
Compatibility Compatible with C-TEC's XFP/ZFP XP95/Discovery Addressable Fire Panels.
Application/operation Monitors temperature by using a single thermistor network which provides a voltage output proportional to the external air temperature. Provides a good response to flaming fires with high heat.
Application temperature 55°C typical, 80°C max.
Power requirements 84°C min, 100°C max.
Static response temperature n/a
Supply wiring 2-wire, polarity insensitive.
Supply/operating voltage 17 to 28V DC.
Quiescent current 250µA average; 500µA peak.
Alarm current 2mA (LED illuminated).
Indicators Clear LED emitting red light when in alarm.
Connections L1&L2 supply in/out; +R remote LED +Ve connection; -R remote LED -Ve connection. (4mA remote LED current @ 5V measured across remote load).
Product dimensions (mm) 100mm diameter x 42 mm H (not in base). 50mm height when in base.
Construction & finish White polycarbonate V.O rated rated to UL94. Stainless steel terminals.
IP Rating IP43.
Weight 105g (not in base); 157g (in base).
Operating conditions/temperature -20ºC to +90ºC.
Notes Requires a BF308XP standard base or BF308XPR low power relay base. 1mA power up surge current for 0.3 seconds.

Accessories

9 other products in the same category: