Flood Sensor (CAST/Hush-Pro Compatible)

CA741

New

  • A C-TEC manufactured flood sensor specifically designed to connect to a CAST or Hush-Pro I/O unit to signal an alarm condition when water is detected.
  • Mounts vertically with the sensor's exposed PCB tracks at floor level.
  • Removable low and side entry bungs allow water to enter the device in a flood situation. 
  • When water is detected the sensor will send an alarm signal to the connected I/O unit which will in turn report it to its CIE.
  • Resets when the I/O unit is commanded by the CIE to reset its zone circuit.
  • Compatible with C-TEC's CA730 CAST I/O module, the CA731 CAST mains switching I/O module, the CA732 CAST zone monitor module, the HP731 Hush Pro FL1 Mains Switching I/O Module and the HP732 Hush Pro FL2 Mains Switching I/O Module.

By buying this product you can collect up to 27 loyalty points. Your cart will total 27 points that can be converted into a voucher of $5.40.


By buying this product you can collect up to 27 loyalty points. Your cart will total 27 points that can be converted into a voucher of $5.40.


Technical Specifications

Compatibility CA730, CA731, CA732, HP731 and HP732 I/O units.
Protocol/compatibility CAST and Hush-Pro
Supply/operating voltage 20V (via CAST or Hush Pro I/O Unit / Zone Monitor)
Product dimensions (mm) 95.5 x 87.5 x 45.5mm
Construction & finish Plastic.
IP Rating IP44 (indoor use).
Weight 100g
Operating conditions/temperature -5ºC to +40ºC. Max relative humidity: 95%.
Notes Conventional Zone EOL can be installed to offer open and short circuit monitoring.

7 other products in the same category: