Apollo XP95 55000-401 High Temperature Detector View larger

Apollo XP95 55000-401 High Temperature Detector

BF303XPH

New

  • A high quality Type CS high temperature (90°C) heat detector.
  • Fully compatible with C-TEC's XFP & ZFP XP95/Discovery Addressable Fire Panels.
  • Monitors temperature by using a single thermistor which provides a voltage output proportional to the external air temperature.
  • Responds well to flaming fires with high heat output.
  • Typically used in areas where smoke detectors cannot be installed such as kitchens.
  • Red LED illuminates when the detector is in alarm.
  • Certified to EN54-5 by the LPCB.
  • Requires a BF308XP standard base or BF308XPR low power relay base.
  • 'Xpert' card addressed for speedy installation.

By buying this product you can collect up to 27 loyalty points. Your cart will total 27 points that can be converted into a voucher of $5.40.


By buying this product you can collect up to 27 loyalty points. Your cart will total 27 points that can be converted into a voucher of $5.40.


Technical Specifications

Approvals/certificationsCertified to EN54-5 by the LPCB.
CompatibilityCompatible with C-TEC's XFP/ZFP XP95/Discovery Addressable Fire Panels.
Application/operationMonitors temperature by using a single thermistor network which provides a voltage output proportional to the external air temperature. Provides a good response to flaming fires with high heat.
Application temperature55°C typical, 80°C max.
Power requirements84°C min, 100°C max.
Static response temperaturen/a
Supply wiring2-wire, polarity insensitive.
Supply/operating voltage17 to 28V DC.
Quiescent current250µA average; 500µA peak.
Alarm current2mA (LED illuminated).
IndicatorsClear LED emitting red light when in alarm.
ConnectionsL1&L2 supply in/out; +R remote LED +Ve connection; -R remote LED -Ve connection. (4mA remote LED current @ 5V measured across remote load).
Product dimensions (mm)100mm diameter x 42 mm H (not in base). 50mm height when in base.
Construction & finishWhite polycarbonate V.O rated rated to UL94. Stainless steel terminals.
IP RatingIP43.
Weight105g (not in base); 157g (in base).
Operating conditions/temperature-20ºC to +90ºC.
NotesRequires a BF308XP standard base or BF308XPR low power relay base. 1mA power up surge current for 0.3 seconds.

Accessories

8 other products in the same category: